![\"Graphic](\"https:\/\/www.nasa.gov\/wp-content\/uploads\/2025\/05\/integrated-testing-timeline.png\")
<\/a><\/figure>Teams responsible for preparing and launching Artemis II<\/a> at NASA\u2019s Kennedy Space Center in Florida are set to begin a series of integrated tests to get ready for the mission. With the upper stage of the agency\u2019s SLS (Space Launch System) integrated with other elements of the rocket, engineers are set to start the tests to confirm rocket and ground systems are working and communicating as planned.<\/p>\n While similar to the integrated testing campaign<\/a> conducted for NASA\u2019s uncrewed Artemis I test flight, engineers have added tests ahead of Artemis II to prepare for NASA\u2019s first crewed flight under the Artemis campaign \u2013 an approximately 10-day journey by four astronauts around the Moon and back. The mission is another step toward missions on the lunar surface and helping the agency prepare for future astronaut missions to Mars.<\/p>\n Verifies the functionality and interoperability of interfaces across elements and systems. Teams will conduct this test from the firing room in the\u00a0Launch Control Center<\/a>\u00a0and perform health and status checks of various systems and interfaces\u00a0between the SLS core stage, the solid rocket boosters, and the ground systems. It will ensure different systems, including core stage engines and booster thrust control, work as planned. Teams also will perform the same series of tests with the interim cryogenic propulsion stage<\/a> and Orion before conducting a final interface test with all segments.<\/p>\n Teams will conduct separate engineering tests for the core stage, rocket boosters, and upper stage following the interface verification tests for each part of the rocket.<\/p>\n Integrated test of SLS core and upper stages, and Orion command and telemetry radio frequencies with mission control at NASA\u2019s Johnson Space Center in Houston to demonstrate flight controllers\u2019 ability to communicate with the ground systems and infrastructure. This test uses a radio frequency antenna in the Vehicle Assembly Building (VAB), another near the launch pad that will cover the first few minutes of launch, as well as a radio frequency that use the Tracking Data Relay Satellite and the Deep Space Network. Teams will do two versions of this test \u2013 one with the ground equipment communicating with a radio and telemetry station for checkouts, and one with all the hardware and equipment communicating with communications infrastructure like it will on launch day.<\/p>\n Teams will conduct a launch day demonstration with the Artemis II astronauts to test launch countdown procedures and make any final necessary adjustments ahead of launch. This test will be divided into two parts. The first will be conducted while SLS and Orion are in the VAB and include the Artemis II crew departing their crew quarters after suiting up at the Neil A. Armstrong Operations and Checkout Building and driving to the VAB where they will enter Orion like they will on launch day and practice getting strapped in. Part two will be completed once the rocket is at the launch pad and will allow the astronauts and Artemis launch team to practice how to use the emergency egress system, which would be used in the event of an unlikely emergency at the launch pad during launch countdown.<\/p>\n Test to ensure the rocket\u2019s flight termination system can be activated in the event of an emergency. For public safety, all rockets are required to have a flight termination system. This test will be divided into two parts inside the VAB. The first will take place ahead of Orion getting stacked atop SLS and the second will occur before the rocket and spacecraft roll out to the launch pad.<\/p>\n Teams will practice loading cryogenic liquid propellant inside SLS once it\u2019s at the launch pad and run through the launch countdown sequences just prior to engine ignition. The rehearsal will run the Artemis II launch team through operations to load liquid hydrogen and liquid oxygen into the rocket\u2019s tanks, conduct a full launch countdown, demonstrate the ability to recycle the countdown clock, and also drain the tanks to give them an opportunity to practice the timelines and procedures they will use for launch.<\/p>\n Teams will load more than 700,000 gallons of cryogenic, or super cold, propellants into the rocket at the launch pad on the mobile launcher according to the detailed timeline they will use on the actual launch day. They will practice every phase of the countdown, including weather briefings, pre-planned holds in the countdown, conditioning and replenishing the propellants as needed, and validation checks. The Artemis II crew will not participate in the rehearsal.<\/p>\n Powered by WPeMatico<\/a><\/small><\/p>\n Get The Details…<\/a> Teams responsible for preparing and launching Artemis II at NASA\u2019s Kennedy Space Center in Florida are set to begin a series of integrated tests to get ready for the mission. With the upper stage of the agency\u2019s SLS (Space Launch System) integrated with other elements of the rocket, engineers are set to start the tests [\u2026] Continue reading Interface Verification Testing<\/h3>\n
Program Specific Engineering Test<\/h3>\n
End-to-End Communications Testing<\/strong><\/h3>\n
Countdown Demonstration Test<\/strong><\/h3>\n
Flight Termination System End-to-End Test<\/strong><\/h3>\n
Wet Dress Rehearsal<\/strong><\/h3>\n
\nElyna Niles-Carnes <\/p>\n","protected":false},"excerpt":{"rendered":"